BendCraft Conduit

Load a real EMT field example, get accurate bend marks in seconds, then copy one clean field note before you bend.

BendCraft Conduit gives electricians accurate EMT bend marks in seconds — no notebook math, less wasted conduit, and fewer second-guess checks at the bender.

Built for field work:

• stub-up 90° marks with automatic take-up for 1/2″ to 1-1/4″ EMT
• back-to-back 90° layout with first mark, second mark, finished spacing, and conduit gain
• offset bend calculator: first mark, second mark, spacing, and shrink for any angle
• rolling offset: converts rise and roll into a true offset with one calculation
• 3-point saddle: center and outside mark positions with shrink allowance
• imperial and metric input with jobsite, precise, or rough rounding
• one-tap field examples so first-time users can start from a real bend layout
• copy-ready field note for mark locations and bend sequence
• save repeat setups to history and pin favorites for quick recall

Why electricians and apprentices choose BendCraft Conduit:

• every result shows the exact bend marks — no guesswork
• first-time users can open a real bend example instead of starting from a blank calculator
• mark, spacing, shrink, take-up, and gain details stay visible so you can double-check before bending
• copy one clean field note when you need to text, call out, or rewrite marks fast
• works offline on the job site — no cell service needed
• one-time purchase, no ads, no account, no subscription
• clean dark-mode interface designed for bright sunlight and dim mechanical rooms

Made for:

• journeyman electricians running standard EMT conduit runs
• apprentices learning stub-up, back-to-back, offset, saddle, and rolling offset math
• electrical contractors who want their crews bending accurately the first time
• anyone who bends pipe and prefers a fast calculator over a codebook