BendCraft Pro: Conduit Bender

Professional conduit bending and electrical calculations for electricians. Offsets, saddles, kicks, voltage drop, conduit fill — completely offline.

BendCraft Pro is a professional conduit bending and electrical calculator built for electricians — on the pole, in the panel, or in the truck.

No subscription. No ads. No accounts. Buy it once, own it forever.

BENDING CALCULATORS — all 10 types • Offset • Stub-Up (90°) • Kick • Three-Point Saddle • Four-Point Saddle • Rolling Offset • Parallel Offset (with gang-bending mode) • Concentric Bends • Segment Bends • Compound Bends

Every calculator shows a live diagram alongside the numbers, so you know exactly where to mark before you bend — not just a number on a screen.

ELECTRICAL CALCULATORS • Voltage Drop — checks your run against the NEC 3% guideline and suggests the smallest conductor size that holds • Conduit Fill — NEC Chapter 9 fill percentage across multiple cable groups, pass/fail at a glance

YOUR OWN BENDER, REMEMBERED Every bender is different. BendCraft Pro doesn't guess with generic manufacturer numbers — measure your own bender once, save it, and every calculation from then on uses your exact take-up and deduction.

BUILT FOR THE FIELD • Fraction or decimal input — whichever you actually use • One-tap PDF export to share a result with your foreman or crew • Flashlight and digital level, built in — one less app to carry • Works completely offline — every calculation runs on your device

PRIVACY, DONE RIGHT No data collected. No accounts. No ads. No tracking. Full stop.

BendCraft Pro is an independent tool for electricians. It is not affiliated with, endorsed by, or sponsored by Greenlee, Klein Tools, Ideal Industries, or the NFPA. All calculations are estimates — always verify against your bender's markings and the current edition of the NEC before cutting or installing.