EG PushButton Configurator

This app can be used to configure the EG Push Button accessibility switch and
can also replace a teacher's button to reset a student's button.

The following two paragraphs provide a rough overview of this app's operation. For
more detailed instructions and all features, plese refer to the push button
documentation.

Resetting and configuring a student's button:

This app can be used instead of a teacher's button to reset a student's button.
To do this, simply turn on the student's button while leaving the associated
teacher's button (if any) off. Start this app, enable Bluetooth if not yet done
and search for push buttons. The student's button should appear in the list.
You can reset the button from this list item already, or access its settings
page to see its internal information (such as number of pushes by student,
current push limit, etc.) and to change the button's configuration. After
changing a configuration value, tap the 'save' icon next to it. If you change
the button number or the button mode, you need to turn the button off and on
again for the changes to take effect.

Configuring a teacher's button:

The only configuration options of a teacher's button are the number of the
student's button that it is associated to and the 'button mode', that determines
if a button works as teacher or student button. To change any of it, turn on the
teacher's button while holding down its push button. Then, start this app,
enable Bluetooth if not yet done and search for push buttons. The teacher's
button should appear in the list. Connect to it by accessing its settings page.
Enter the new button number of the student's button to be associated with this
teacher's button or change the button mode and tap the 'save' icon next to it.
Turn the teacher's button off and on again for the changes to take effect.