civstraw005

What you can do with civstraw (civstraw005)
*Requires pairing with ICOM IC-705 via bluetooth
If you are unable to connect to the IC-705, turning off and on your smartphone's bluetooth will make it easier to connect.
*When offline, you can change the CIV address by reading List on page 3 and reading CIV address.TXT.
*Turn on the transceiver of the device MENU SET>External terminal>CI-V CI-V transceive ON

1. Reading and writing frequency list
1) Pre-information is written in ROM_assets (read-only), so read it
2) Tap save to restore to a readable/writable file (RAM_writable)
3) The list can be changed using (RAM_writable)
4) Tap READ frequency book to read
2. Utilization of list
1) Send information to the transceiver using frequency, mode (LSB.., etc.), filter (FIL1.., etc.) taps
2) Tap the scan button (STOP → START) to scan the frequencies on the list, and stop for about 2 seconds when the squelch opens.
3) You can change frequency information (list) with the filter tap
4) Frequencies and notes can be sorted in ascending or descending order.
5) To delete, swipe the row to the left
6) To rearrange one line, touch the line to move it up or down.
7) Commands are pre-registered for experimental use. Operate valid commands on P.2
3.Frequency change
1) Change by operating the slide bar or tapping the frequency display
4.Voice, squelch level, variable notch, IF adjustment, voice
1) P.1 button tap or P3 right image tap
5. Finish The finish button is on p.3.
1) There is an exit button on P.3
6.CIV address and Bluetooth device name settings
1) Read the CIV address in the frequency book and tap the corresponding model
*We have not confirmed anything other than IC-705, so please change it in the list.
*Valid with CIV address .TXT under READ frequency book (tap READ frequency book to return)

7. About frequency steps
1) It is not a setting inside the device.
*Can be changed in stages from 0.001 to 10000KHz
2) Transceiver TS settings are also implemented
8.Energy saving sw
1) To read the S meter, frequency, etc., commands are run using a timer, so if you are concerned about battery consumption, please turn it on.